Analog Output (X8)

Analog Outputs can be used to output converted analog values of digital measurements recorded in the drive. The standard drive offers one analog output on X8. A list of the pre-programmed functions is included in the WorkBench setup software.

Technical characteristics

• Output voltage range referring to AGND: ±10 V
• Resolution: 16 Bit and fully monotonic
• Update rate: 4 kHz
• Unadjusted offset: < 50 mV
• Offset drift typ: 250 µV/°C
• Gain or slope tolerance: +/- 3%
• Nonlinearity: < 0.1% of full scale or 20 mV
• Output impedance: 110 ohms
• Specification complies with IEC"International Electrotechnical Commission" IEC is a not-for-profit, non-governmental international standards organization that prepares and publishes International Standards for all electrical, electronic and related technologies 61131-2 Table 11
• -3 dB BandwidthIn computer networking, bandwidth often refers to a data rate measured in bits/s, for example, network throughput. The reason for the connection of data rate with the term bandwidth is that the limit to the data rate of a physical communication link is related to its bandwidth in hertz: >8 kHz
• Maximum output current: 20 mA
• Capacitive load: any value but response speed limited by max Iout and by Rout
• Protected for short circuit to AGND

Analog Output Wiring Diagram